Download Fortinet NSE7_SDW-6.4 Mock Test Study Material
NSE7_SDW-6.4 Questions Prepare with Learning Information
NEW QUESTION 21
An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers. The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links. One link has random jitter and latency issues, and is based on a wireless connection.
Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD-WAN rules? (Choose two.)
- A. Use the performance SLA targets to detect latency and jitter instantly.
- B. Configure an SD-WAN rule to load balance all traffic without VoIP.
- C. Place the troublesome link at the top of the interface preference list.
- D. Choose the suitable interface based on the interface cost and weight.
- E. Select the corresponding SD-WAN balancing strategy in the SD-WAN rule.
Answer: A,E
NEW QUESTION 22
Which components make up the secure SD-WAN solution?
- A. Application, antivirus, and URL, and SSL inspection
- B. FortiGate, FortiManager, FortiAnalyzer, and FortiDeploy
- C. Telephone, ISDN, and telecom network.
- D. Datacenter, branch offices, and public cloud
Answer: A
NEW QUESTION 23
Which two statements reflect the benefits of implementing the ADVPN solution to replace conventional VPN topologies? (Choose two )
- A. It creates redundant tunnels between hub-and-spokes, in case failure takes place on the primary links.
- B. It provides direct connectivity between all sites by creating on-demand tunnels between spokes.
- C. It ensures that spoke-to-spoke traffic no longer needs to flow through the tunnels through the hub.
- D. It dynamically assigns cost and weight between the hub and the spokes, based on the physical distance.
Answer: B,C
NEW QUESTION 24
Which components make up the secure SD-WAN solution?
- A. Telephone, ISDN, and telecom network.
- B. Datacenter, branch offices, and public cloud
- C. FortiGate, FortiManager, FortiAnalyzer, and FortiDeploy
- D. Application, antivirus, and URL, and SSL inspection
Answer: C
NEW QUESTION 25
Refer to the exhibit.
Which two statements about the status of the VPN tunnel are true? <Choose two )
- A. VPN static routes are prevented from populating the FortiGate routing table
- B. 100.64.3.1 is one of the remote IP address that comes through index interlace 1.
- C. There are separate virtual interfaces for each dial-up client
- D. FortiGate created a single IPsec virtual interface that is shared by all clients
Answer: C
NEW QUESTION 26
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A. Set priority 10.
- B. Set source 100.64.1.1.
- C. Set load-balance-mode source-ip-ip-based.
- D. Set cost 15.
Answer: B
NEW QUESTION 27
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?
- A. diagnose sys virtual-wan-link sla-log
- B. diagnose sys virtual-wan-link log
- C. diagnose sys virtual-wan-link intf-sla-log
- D. diagnose sys virtual-wan-link health-check
Answer: A
Explanation:
Explanation/Reference: https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/943037/sla-logging
NEW QUESTION 28
Refer to the exhibit.
Which two statements about the status of the VPN tunnel are true? <Choose two )
- A. VPN static routes are prevented from populating the FortiGate routing table.
- B. FortiGate created a single IPsec virtual interface that is shared by all clients.
- C. There are separate virtual interfaces for each dial-up client.
- D. 100.64.3.1 is one of the remote IP address that comes through index interface 1.
Answer: B,D
NEW QUESTION 29
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?
- A. diagnose sys virtual-wan-link sla-log
- B. diagnose sys virtual-wan-link log
- C. diagnose sys virtual-wan-link intf-sla-log
- D. diagnose sys virtual-wan-link health-check
Answer: A
NEW QUESTION 30
Refer to the exhibit.
Which statement about the trace evaluation by FomGate is true?
- A. Packets exceeding the configured maximum concurrent connection limit are denied by the per-IP shaper.
- B. The packet exceeded the configured maximum bandwidth and was dropped by the shared shaper.
- C. The packet exceeded the configured bandwidth and was dropped based on the priority configuration
- D. Packets exceeding the configured concurrent connection limit are dropped based on tfte priority configuration.
Answer: D
NEW QUESTION 31
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two )
- A. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
- B. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.
- C. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.
- D. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.
Answer: B,D
NEW QUESTION 32
Refer to the exhibit.
Which statement about the command route-tag in the SD-WAN rule is true?
- A. It tags each route and references the tag in the routing table.
- B. It ensures route tags match the SD-WAN rule based on the rule order
- C. It uses route tags for a BGP community and assigns the SD-WAN rules with same tag.
- D. It enables the SD-WAN rule to load balance and assign traffic with a route tag
Answer: B
NEW QUESTION 33
Refer to exhibits.
Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.
Based on the exhibits, which statement is correct?
- A. SD-WAN member interfaces are affected by the SLA state of the inactive interface.
- B. Both SD-WAN member interfaces have used separate SLA targets.
- C. Port1 became dead because no traffic was offload through the egress of port1.
- D. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
Answer: D
NEW QUESTION 34
Refer to exhibits.
Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?
- A. The reverse shaper option must be enabled and a traffic shaper must be selected
- B. The guaranteed-10mbps option must be selected as the reverse shaper option.
- C. A new firewall policy must be created and SD-WAN must be selected as the incoming interface.
- D. The guaranteed-10mbps option must be selected as the per-IP shaper option
Answer: B
NEW QUESTION 35
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. ADVPN should only be enabled on unmanaged FortiGate devices.
- B. The protected subnets should be set to address object to all (0.0 .0. o/o).
- C. Each VPN device has a unique pre-shared key configured separately on phase one
- D. On the hub VPN, only the device needs additional phase one sett
Answer: C
NEW QUESTION 36
Which statement reflects how BGP tags work with SD-WAN rules?
- A. BGP tags match the SD-WAN rule based on the order that these rules were installed.
- B. Route tags are used for a BGP community and the SD-WAN rules are assigned the same tag
- C. VPN topologies are formed using only BGP dynamic routing with SD-WAN
- D. BGP tags require that the adding of static routes be enabled on all ADVPN interfaces
Answer: A
NEW QUESTION 37
In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two )
- A. Matched traffic failed RPF and was caught by the rule.
- B. Traffic has matched none of the FortiGate policy routes.
- C. The FIB lookup resolved interface was the SD-WAN interface.
- D. An absolute SD-WAN rule was defined and matched traffic.
Answer: B,C
NEW QUESTION 38
Which statement about using BGP routes in SD-WAN is true?
- A. VPN topologies must be form using only BGP dynamic routing with SD-WAN
- B. Learned routes can be used as dynamic destinations in SD-WAN rules
- C. Adding static routes must be enabled on all ADVPN interfaces.
- D. Dynamic routing protocols can be used only with non-encrypted traffic
Answer: B
NEW QUESTION 39
Refer to the exhibit.
Which two statements about the debug output are correct? (Choose two )
- A. The debug output shows per-lP shaper values and real-time readings.
- B. FortiGate provides statistics and readings based on historical traffic logs.
- C. This traffic shaper drops traffic that exceeds the set limits.
- D. Traffic being controlled by the traffic shaper is under 1 Kbps
Answer: A,B
NEW QUESTION 40
Refer to the exhibit.
Which two statements about the debug output are correct? (Choose two )
- A. The debug output shows per-IP shaper values and real-time readings.
- B. FortiGate provides statistics and reading based on historical traffic logs.
- C. This traffic shaper drops traffic that exceeds the set limits.
- D. Traffic being controlled by the traffic shaper is under 1 Kbps.
Answer: A,C
NEW QUESTION 41
......
Fortinet NSE7_SDW-6.4 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
Most Reliable Fortinet NSE7_SDW-6.4 Training Materials: https://passguide.dumpexams.com/NSE7_SDW-6.4-vce-torrent.html